Skip to Content
  • Proceeding Paper
  • Open Access

13 November 2026

Modelling and Optimization of Surface Roughness and Material Removal Rate in Wire Electrical Discharge Machining of Nimonic 90 †

,
and
1
Department of Mechanical Engineering, CVR College of Engineering, Hyderabad 501510, Telangana, India
2
School of Materials Science and Engineering, Engineering Research Institute, Gyeongsang National University, Jinju-si 52725, Republic of Korea
*
Authors to whom correspondence should be addressed.
†
Presented at the 4th International Conference on Advanced Manufacturing and Materials Processing (AdvaMAP 2026), Porto, Portugal, 19 July 2026.
Eng. Proc.2026, 165(1), 6;https://doi.org/10.3390/engproc2026165006 
(registering DOI)

Abstract

Optimal process conditions are key for obtaining the desired machinability in machining processes. This study uses an optimization approach for wire electrical discharge machining (WEDM) of Nimonic 90. Surface roughness and material removal rate (MRR) are considered as process responses. WEDM experiments were conducted under different levels of process inputs. Response surface methodology (RSM) and the desirability function approach were used to model the process inputs and outputs. The optimal machining conditions were a servo voltage of 30 V, wire tension of 4 N, wire feed rate of 3 mm/min, pulse on time of 7.97 µs, and pulse off time of 38.48 µs, resulting in an overall desirability of 0.68. The developed models were validated through confirmation tests. The models showed good agreement with the experimental results, with correlation coefficients of 0.97 for surface roughness and 0.99 for MRR. The proposed approach provides a useful tool for WEDM process modelling and optimization.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.