Skip to Content
  • Proceeding Paper
  • Open Access

12 November 2026

Experimental Assessment of Autogenous TIG-Welded Dissimilar Thin High-Strength Steel Sheets †

and
Department of Innovative Vehicles and Materials, GAMF Faculty of Mechanical Engineering and Computer Science, John von Neumann University, H-6000 Kecskemét, Hungary
*
Author to whom correspondence should be addressed.
†
Presented at the Sustainable Mobility and Transportation Symposium 2026, Győr, Hungary, 8 October 2026.

Abstract

High-strength structural steels are widely used in lightweight engineering, but welding thin dissimilar sheets remains challenging because joint performance depends on the thermal cycle. This study evaluates autogenous TIG welding of 1 mm DOCOL 1500M, DP1000, and DOMEX 420 steel sheets. Butt joints were produced in three material pairings using three current–travel speed combinations, ranging from conservative to productivity-oriented conditions. Tensile tests were used to assess joint performance and define a practical process window. All material combinations were welded successfully within the investigated range. The results showed only minor differences between welding conditions, indicating stable tensile behavior for the selected thin-sheet joints. DOCOL 1500M–DP1000 joints achieved the highest strength, while DOMEX 420-containing joints showed lower strength but favorable fracture behavior outside the weld region. The findings confirm the suitability of autogenous TIG welding for selected dissimilar high-strength steel sheets.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.