Skip to Content
  • Proceeding Paper
  • Open Access

8 September 2026

13 Pages

Investigation of the Influence of 3D-Printing Mode on the Accuracy of Geometric Shape †

,
,
,
,
and
1
Department of Manufacturing Engineering and Technologies, Technical University Sofia, Plovdiv Branch, 25 Tsanko Dyustabanov Str., 4000 Plovdiv, Bulgaria
2
Center of Competence “Smart Mechatronic, Eco- and Energy-Saving Systems and Technologies”, 4000 Plovdiv, Bulgaria
3
Department of Mechanics, Faculty of Mechanical Engineering, Technical University Sofia, Plovdiv Branch, 25 Tsanko Dyustabanov Str., 4000 Plovdiv, Bulgaria
*
Author to whom correspondence should be addressed.

Abstract

In modern mechanical engineering, the requirements for surface roughness, geometric and dimensional accuracy are constantly increasing, as these characteristics are critical for the reliability, durability and functional application of products. The parameters of 3D printing significantly affect the quality, accuracy and physico-mechanical properties of the manufactured parts. This, in turn, necessitates a deeper understanding of the influence of printing modes on the accuracy and physico-mechanical properties of the printed component. The present study aims to determine the effect of the main technological parameters of the FFF process—printing speed and layer height—on the geometric accuracy and surface roughness of a functional machine element. For this purpose, a central composite design of experiments was developed to optimize both the process and the product. PETG was selected as the experimental material. The obtained results show that the layer height is the dominant factor influencing the roughness of the printed surface, while the printing speed exhibits a nonlinear effect within the considered range. The developed regression model allows determining an optimal range of printing parameters that achieves minimal surface roughness and high geometric accuracy of the part.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.