Abstract
The global scarcity of potable water necessitates the development of efficient and low-cost desalination technologies. This study presents an experimental investigation into enhancing the productivity of a conventional single-slope solar still (SSSS) by employing natural jute cloth and nano-enhanced jute cloth as novel wick materials. The primary objective was to compare the performance of the modified stills with that of a conventional still under identical climatic conditions. The jute cloth was dip-coated with carbon black nanoparticles and a polyvinyl alcohol (PVA) binder to create a nano-enhanced wick with higher solar absorptivity. Three identical solar stills were fabricated and tested simultaneously on a representative clear-sky day: a conventional still (CSS), a still with jute cloth (JSS), and a still with nano-enhanced jute cloth (NJSS). Key performance parameters, including daily water yield, internal heat and mass transfer, and thermal efficiency, were meticulously measured and analysed. The experimental results demonstrated a significant improvement in productivity for the modified stills. The cumulative daily water yield for the CSS was 2.1 L/m2. The JSS showed a marginal increase, producing 3.0 L/m2, an improvement of about 43%. The NJSS outperformed both, achieving a yield of 3.8 L/m2, which was relatively higher by about 81% compared to the conventional case. The efficiency of the CSS was 34%, increasing to 42% for the JSS and 51% for the NJSS. The enhancement is attributed mainly to thin-film evaporation sustained by capillary action in the wick and to the superior photothermal conversion of the carbon black/PVA coating, resulting in higher basin water temperatures.