Skip to Content
ProceedingsProceedings
  • Abstract
  • Open Access

28 May 2024

1 Page

Study of Structure and Electrochemical Properties of LaFeO3 and La2FeO4 as Electrode Materials for Super-Capacitor Application †

,
,
and
1
Department of Physics, Indian Institute of Technology, Banaras Hindu University, Varanasi 221005, India
2
Department of Physics, Mahila Maha Vidyalaya College, Banaras Hindu University, Varanasi 221005, India
*
Author to whom correspondence should be addressed.
†
Presented at the 3rd International Electronic Conference on Processes—Green and Sustainable Process Engineering and Process Systems Engineering (ECP 2024), 29–31 May 2024; Available online: https://sciforum.net/event/ECP2024.
Perovskite oxides have introduced a new advancement in the field of energy storage technologies, because of their outstanding properties. Perovskite oxides are a diverse and exciting class of compounds that have attracted a lot of interest. Perovskite oxides have attracted considerable interest as potential electrode materials for supercapacitors due to their unique structure, compositional flexibility, and intrinsic oxygen vacancy. Synthesized single-phase perovskite LaFeO3 and its 2D equivalent Ruddlesden-Popper oxide La2FeO4 were obtained via a solid-state reaction method. X-ray diffraction and field emission scanning electron microscopy techniques have been used to study the crystal structure and surface morphology of the produced materials, respectively. The optical band gap for LaFeO3 is 2.10 eV, while for La2FeO4, it is 2.04 eV, as determined by UV-vis measurements. Electrochemical impedance spectroscopy (EIS), charge/discharge analysis, and cyclic voltammetry have been used to study the electrochemical characteristics. Both of the samples exhibited typical pseudocapacitor behavior, as indicated by the presence of a redox peak in cyclic voltammetry, which was recorded in the potential window of 0 to −1 V. For both the compounds, the faradic charge transfer resistance (Rct) was determined to be ~1 Ω. After 100 cycles of the charge/discharge testing, the specific capacitance in a 3M KOH electrolyte solution is found to be 6 Fg-1 and 10 Fg-1, respectively for LaFeO3 and La2FeO4.

Author Contributions

H.V., writing—original draft, methodology, conceptualization, visualization, investigation. P.K., review. B.B., resources. S.U., supervision, review and editing. All authors have read and agreed to the published version of the manuscript.

Funding

This research received no external funding.

Institutional Review Board Statement

The Institutional Review Board at [Indian Institute of Technology, Banaras Hindu University, Varanasi] reviewed and approved this study.

Data Availability Statement

Data required to reproduce experimental findings cannot be shared as data also forms part of ongoing studies for a research.

Conflicts of Interest

The authors declare no conflict of interest.
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.