Abstract
Non-mechanical beam steering technology based on liquid crystal optical switches and liquid crystal polarization gratings holds significant application prospects in fields such as laser communication, radar detection, and optical information processing. Traditional nematic liquid crystal optical switches exhibit slow response speeds, whereas novel ferroelectric liquid crystal optical switches, despite their fast response, are hampered in engineering applications by complex fabrication processes, the large number of devices required for cascading, and substantial module thickness. To address these issues, this paper proposes and demonstrates a fast non-mechanical beam steering scheme by cascading a stressed polymer network liquid crystal (SPNLC) optical switch with a liquid crystal polarization grating. The SPNLC is fabricated by mechanically shearing a polymerized liquid crystal–polymer composite, enabling sub-millisecond response and continuous linear phase modulation without the need for an alignment layer. A 30-μm-thick SPNLC half-wave plate was prepared, which introduces a phase retardation of 3.6 μm under a driving voltage of 300 V, and the rise time and fall time are measured to be approximately 526 μs and 560 μs at a driving voltage of 20 V with a 1 kHz square wave, and 470 μs and 538 μs at 27 V under the same waveform conditions. Cascaded with a passive polarization grating, the waveplate enables fast electrical switching of the beam between the ±1st diffraction orders. Furthermore, a two-dimensional multi-angle beam deflector was constructed based on a supra-binary cascade scheme. Experimental results confirm that the system possesses sub-millisecond response, large phase retardation, continuous tunability, and an alignment-layer-free fabrication process, demonstrating its feasibility for large-range fast beam scanning.