Skip to Content
You are currently on the new version of our website. Access the old version .
CoatingsCoatings
  • Article
  • Open Access

13 September 2021

12 Pages

The Device Using a Polydimethylsiloxane Membrane and the Phase Transition of Water

,
,
,
and
CAS Key Laboratory of Mechanical Behavior and Design of Materials, CAS Center for Excellence in Complex System Mechanics, Department of Modern Mechanics, University of Science and Technology of China, Hefei 230027, China
*
Author to whom correspondence should be addressed.

Abstract

The accumulation of ice on surfaces can cause harm in many industries. Our work describes an experiment and a simulation of the deicing effect based on a simple device combining a polydimethylsiloxane (PDMS) membrane and water phase transition. The device resulted in a minimum ice adhesion strength of 0.327 kPa, and the ice adhesion strength was still less than 5 kPa after 15 cycles, which meets the requirements of automatic deicing. It also held up after flushing with water and sand currents. In addition, our finite element simulation illustrates that the ice adhesion strength decreases greatly due to the change in initial stress distribution and the separation mode of ice. The fracture between the ice and membrane initiates from one side, and propagates gradually along the contour of ice while at the same time spreading rapidly towards the center. Compared with other icephobic methods, such as expensive and vulnerable micro/nano-surfaces or functional composite coatings, this low-cost and environment friendly device appears promising for large-scale deicing applications in various engineering fields.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.