Skip to Content
BuildingsBuildings
  • Article
  • Open Access

28 March 2026

16 Pages

Controlling Performance and Parameters Investigation of the Improved Mega-Sub Controlled Structural System (MSCSS) for a Tall Building

,
,
,
and
1
School of Mechanics, Civil Engineering and Architecture, Northwestern Polytechnical University, Xi’an 710072, China
2
Department of Civil Engineering, Air Force Institute of Technology (AFT), Nigerian Air Force, P.M.B. 2104, Kaduna 800283, Nigeria
3
Department of Civil Engineering, North China University of Water Resources and Electric Power, Zhengzhou 450046, China
4
Engineering Management Department, College of Engineering, Prince Sultan University, Riyadh 11586, Saudi Arabia
This article belongs to the Section Building Structures

Abstract

The study presented a newly proposed mega-sub controlled structure system (MSCSS), connected to the design and building of high-rise structures, as enhanced durability and efficiency of mega-structural frames attracted the attention of researchers. In this article, a more reasonable and advanced mega-sub controlled structure model is designed and investigated under wind load. The complex model analysis theory is used to generate the equations of motion, the response spectrum (RS) expression, and the mean square response (MSR). The dynamic features that influence the control response of MSCSS, such as relative stiffness ratio (RD) and relative mass ratio (MR) between the mega-frame and substructure, are defined and investigated. The result showed that the displacement effectiveness is highly effective at low stiffness ratios, with a sharp decrease in maximum displacement observed when RD is less than 0.17 (RD < 0.17). Optimal response control effectiveness was identified within the RD range of 0.17 to 0.6. Also, the result indicates better acceleration control effectiveness when RD is between 0.3 and 0.5; however, this control decreases significantly when RD > 0.6. Furthermore, the study reveals that increasing the relative mass ratio obviously improves both displacement and acceleration control effectiveness at fixed RD = 0.3.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.