Skip to Content
PolymersPolymers
  • Article
  • Open Access

24 September 2024

9 Pages

Thermomechanical Assessment of Recovered PA12 Powders with Basalt Filler for Automotive Components

,
,
,
and
1
Institute of Polymers, Composites and Biomaterials, National Research Council, Via Campi Flegrei 34, 80078 Pozzuoli, Italy
2
Department of Chemical, Materials and Production Engineering, University of Naples “Federico II”, P.le Tecchio 80, 80125 Naples, Italy
*
Author to whom correspondence should be addressed.

Abstract

Additive manufacturing processes allow for precise and efficient production, but it is estimated that one-third of the materials used results in waste. Further improvement in a sustainable perspective could come from the ability to manage these scraps and from the exploration of different routes for recovery and reuse. The Selective Laser Sintering process is particularly sensitive to this issue due to the waste ratio which can reach a very high quantity of not-sintered virgin powders. In this research study, recovered PA12 powders, preliminarily characterized through thermal and mechanical analysis, were mixed with 15% basalt powder to improve their aspect and thermomechanical resistance. The influence of basalt powder (BP) on mechanical properties as well as on the thermal stability of polyamide12 (PA12) powder composites was investigated. A study conducted on mechanical properties showed that polymeric composites’ stiffness and hardness were influenced by adding filler, thus improving mechanical parameters. On the other hand, the application of thermogravimetric analysis allowed us to determine the composite’s thermal stability. The objective is to obtain a recovered fully biobased material that could be used to substitute the petroleum-derived polymeric ones currently employed in the production of interiors and shells in the automotive sector.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.