Skip to Content
CatalystsCatalysts
  • Editor’s Choice
  • Article
  • Open Access

19 September 2022

12 Pages

Semi-Hydrogenation of Acetylene to Ethylene Catalyzed by Bimetallic CuNi/ZSM-12 Catalysts

,
,
,
,
,
,
,
and
1
State Key Laboratory of Green Chemical Engineering and Industrial Catalysis, Department of Process Development and Design, Shanghai Research Institute of Petrochemical Technology, Shanghai 201208, China
2
Key Laboratory of Jiangxi Province for Environment and Energy Catalysis, Institute of Applied Chemistry, College of Chemistry and Chemical Engineering, Nanchang University, Nanchang 330031, China
*
Authors to whom correspondence should be addressed.

Abstract

The purpose of this work is to develop a low-cost and high-performance catalyst for the selective catalytic hydrogenation of acetylene to ethylene. Non-precious metals Cu and Ni were selected as active ingredients for this study. Using ZSM-12 as a carrier, Cu-Ni bimetallic catalysts of CuNix/ZSM-12 (x = 5, 7, 9, 11) with different Ni/Cu ratios were prepared by incipient wetness impregnation method. The total Cu and Ni loading were 2 wt%. Under the optimal reaction conditions, the acetylene conversion was 100%, and the ethylene selectivity was 82.48%. The CuNi7/ZSM-12 prepared in this work exhibits good performance in the semi-hydrogenation of acetylene to ethylene with low cost and has potential for industrial application.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.