Skip to Content
You are currently on the new version of our website. Access the old version .
AlgorithmsAlgorithms
  • Article
  • Open Access

6 September 2022

28 Pages

Joining Constraint Satisfaction Problems and Configurable CAD Product Models: A Step-by-Step Implementation Guide

Institute of Product Development, Leibniz University Hanover, An der Universität 1, 30823 Garbsen, Germany

Abstract

In configuration design, the task is to compose a system out of a set of predefined, modu-lar building blocks assembled by defined interfaces. Product configuration systems, both with or without integration of geometric models, implement reasoning techniques to model and explore the resulting solution spaces. Among others, the formulation of constraint satisfaction problems (CSP) is state of the art and the informational background in many proprietary configuration engine software packages. Basically, configuration design tasks can also be implemented in modern computer aided design (CAD) systems as these contain different techniques for knowledge-based product modeling but literature reports only little about detailed application examples, best practices or training materials. This article aims at bridging this gap and presents a step-by-step implementation guide for CSP-based CAD configurators for combinatorial designs with the example of Autodesk Inventor.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.