Skip to Content
MaterialsMaterials
  • Article
  • Open Access

18 November 2026

15 Pages

Miniature Tensile-Shear Testing of Local Shear Bonding Strength in AFSD Al6061 Cladding

,
,
and
Department of Mechanical and Industrial Engineering, Louisiana State University, Baton Rouge, LA 70803, USA
*
Authors to whom correspondence should be addressed.
This article belongs to the Section Materials Simulation and Design

Abstract

Cladding and repair processes require strong bonding between the deposited material and the original substrate. Additive Friction Stir Deposition (AFSD) is a promising solid-state process for these applications, but the local bonding strength of AFSD-deposited Al6061 has not been thoroughly examined. Thin cladding layers are difficult to evaluate using conventional large tensile-shear specimens. In this study, a miniature tensile shear specimen was designed to measure local shear strength within a thin AFSD Al6061 cladding layer. The shear strength was measured at the substrate/deposit interface and at 0.5 mm above the interface within the deposited layer. Finite element analysis was used to evaluate the stress distribution in the specimen. The results showed that the selected specimen geometry concentrated stress in the target region, supporting its use for localized shear-strength measurement. The average shear strength was about 159 MPa at the substrate/deposit interface and 139 MPa at 0.5 mm above the interface within the layer. The interface strength was about 79% of the shear strength of bulk Al6061-T6, showing strong bonding between the deposited material and the substrate. The results also showed that the interface was stronger than the cladding material tested 0.5 mm above it. EBSD analysis showed substantial grain refinement after AFSD. The average grain size was 8.07 µm at the interface and 15.53 µm at 0.5 mm above the interface, compared with 193.82 µm in the original substrate. The finer grains at the interface contribute to the high shear strength. Overall, the results show that the miniature tensile-shear specimen can provide localized mechanical information in thin cladding layers and that AFSD can produce strong bonding between the Al6061 deposit and substrate.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.