Abstract
High-power fiber laser cutting produces localized thermal cycles that influence the hardness of wear-resistant steels. This study investigates hardness variations in 10 mm Hardox 400 plate and uses thermal analysis to interpret the experimental response. A factorial design comprising the main conditions combined laser powers of 5100–5200 W, cutting speeds of 1150–1350 mm/min and focal positions from −8 to −6 mm. The measured hardness ranged from 26.5 to 50.9 HRC, with the maximum recorded at 5150 W, 1350 mm/min, and −7 mm. For selected conditions, measured heat-affected-zone widths of 150–260 µm were compared with numerical estimates, yielding a mean absolute error of 10 µm. The highest Rockwell hardness coincided with the widest measured heat-affected zone and the highest near-edge micro-hardness, decreasing from 520 HV to 385 HV (0.2 at 0.50 mm) from the edge. These observations support a spatial association between thermal exposure and hardness response. Thermal fields provide a qualitative interpretation of localized heating and cooling. Additionally, the quadratic model showed performance (R2 = 0.423; adjusted R2 = 0.117; Q2 = −0.244), supporting exploratory interpretation rather than validated process optimization.