Skip to Content
MaterialsMaterials
  • Correction
  • Open Access

18 November 2026

2 Pages

Correction: Wu et al. The Effects of Compressive Residual Stress on Properties of Mullite-Coated Zirconia Toughened Alumina Ceramics. Materials 2023, 16, 6071

,
,
,
,
and
1
China Building Material Test & Certification Group Co., Ltd., Beijing 100024, China
2
State Key Laboratory of Green Building Materials, China Building Materials Academy, Beijing 100024, China
*
Author to whom correspondence should be addressed.
The journal’s Editorial Office and Editorial Board are jointly issuing a resolution and removal of the Journal Notice linked to this article [1], as well as an update to the original publication. Following concerns raised about the integrity of the peer review, the Editorial Office has conducted a post-publication peer review of this article. This process included the recruitment of a new independent reviewer, and it was supervised by an Editorial Board member and Section Editor-in-Chief to ensure full compliance with MDPI’s Editorial Process (https://www.mdpi.com/editorial_process).
As a result of this process, the Editorial Board member, Section Editor-in-Chief, and the authors have agreed to update the following aspects of this publication:
  • There was an update to the Academic Editors. The Academic Editors who conducted this post-publication review have been added.
  • In the title, Abstract, Keywords, and the Sections of Introduction, Experiments, Results and Discussion, and Conclusions, the word “Kyanite” has been changed to “Mullite”.
  • In Section 2.1, Paragraph 1, the sentence “After mixing, the weight ratio of the ball to the powder is 5:1.” is updated to “After mixing, the weight ratio of the ball to the powder is 5:1 (Agate spheres, diameter ranging from 20 mm to 200 mm).”
  • In Section 2.2, Paragraph 1, the sentence “Analyzing changes in composition during the sintering process through XRD characterization.” is added before the words “The elastic”.
  • The Figure 4 caption is updated from “Figure 4. Temperature-dependent curves of the flexural strength of substrate and composite.” to “Figure 4. Temperature-dependent curves of the flexural strength of substrate and composite. Measured by “Model C45, MTS”.”
  • The Figure 5 caption is updated from “Figure 5. Residual flexural strength of substrate and composite measured after quenching at different temperatures.” to “Figure 5. Residual flexural strength of substrate and composite measured after quenching at different temperatures. Measured by “Model C45, MTS”.”
With this update, the Academic Editors are satisfied that the Editorial Process relating to this article has been completed as per MDPI’s Editorial Process policy. The Editorial Office would like to thank the authors for their collaboration during this process.

Reference

  1. Wu, H.-L.; Li, H.; Cao, D.; Qiu, Y.; Wan, D.; Bao, Y. The Effects of Compressive Residual Stress on Properties of Mullite-Coated Zirconia Toughened Alumina Ceramics. Materials 2023, 16, 6071. [Google Scholar] [CrossRef] [Scilit]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.