Abstract
In view of the structural characteristics of multi-cavity box sections, an integrated resin transfer molding (RTM) process was developed in this study. The rheological properties of the AC520RTM resin system were investigated. The results indicate that this resin system features low viscosity and a long pot life, making it suitable for the RTM fabrication of multi-cavity box sections. Combined with the structural design, layup design and mold design of the box section, process validation for manufacturing composite large length-to-width ratio multi-cavity box sections via integrated RTM forming technology was conducted. Ultrasonic A-scan inspection and destructive analysis on process-equivalent coupons were performed, and the porosity was determined to be below 0.5%. Deformation analysis was conducted for the box section, indicating that 94.59% of the profile deviations fall within 3 mm. A single specimen was subjected to the room temperature static strength test. The test results show that audible sounds occurred in the specimen once the load reaches 80% of the limit load. The maximum failure strain reaches 4689 με, and the failure load is 15,087 N, corresponding to 150.9% of the limit load and 100.6% of the ultimate load.