Abstract
Traditional magnesium oxychloride cement generally uses reactive MgO obtained by calcination. This study uses commercial, uncalcined hydromagnesite (HY; 4MgCO3·Mg(OH)2·4H2O) to examine ambient-temperature hardening in a HY–MgCl2–H2O system. MgCl2 dosage was varied over nominal concentrations of 0–2.00 mol L−1 relative to the initial water volume. Compressive strength, calorimetry, XRD, XPS, Raman spectroscopy, SEM–EDS, mercury intrusion porosimetry and TG–DTG were combined to evaluate phase composition, surface chemistry, particle organization and thermal behaviour. The water-only control reached approximately 2.8 MPa at 28 d; particle-surface interactions may contribute to its consolidation. The 28 d compressive strength showed a non-monotonic dependence, reaching 6.5 MPa at 1.00 mol L−1, approximately 2.3 times the control. HY remained the dominant crystalline phase, with no conclusively identified new chlorine-containing crystalline phase. MgCl2 treatment accompanied changes in surface carbon and chlorine signals, water-associated Raman bands, reported poorly crystalline fractions and accessible pore-size distributions. The strength maximum did not coincide with the lowest total intrusion volume or the strongest thermal shifts. Together, these observations are consistent with a concentration-dependent interfacial interpretation of the hardening response. The route avoids calcining HY during specimen preparation.