Skip to Content
MaterialsMaterials
  • Article
  • Open Access

15 November 2026

22 Pages

Numerical and Experimental Analysis of the Influence of Composite Insert Layers on the Ballistic Performance of Hybrid Soft Body Armors

and
Institute of Architecture of Textiles, Faculty of Textiles and Design, Lodz University of Technology, 116 Żeromskiego Street, 90-924 Lodz, Poland
*
Author to whom correspondence should be addressed.
This article belongs to the Section Advanced Composites

Abstract

Although traditional multi-ply textile ballistic packs effectively arrest handgun bullets, they often undergo excessive dynamic deflection toward the body, measured as Back-Face Signature (BFS). This can transfer impact energy to the wearer and cause life-threatening non-penetrating internal injuries, known as Behind-Armor Blunt Trauma (BABT). Incorporating rigid fiber-reinforced composite inserts into hybrid systems dissipates this energy over a larger area; however, selecting the optimal number of composite plies remains a key challenge in balancing maximum protection with the wearer’s mobility. To address this, this paper presents a numerical (LS-DYNA) and experimental analysis of a 9 mm Luger bullet (380 m/s) impacting a hybrid panel. The system comprised a 30-ply soft Twaron CT709 fabric backing and an epoxy/Twaron woven composite insert of 8, 12, or 20 layers. After calibrating the computational models, simulations were validated via ballistic range tests. During these tests, all variants successfully arrested the bullet and maintained BFS safely below the 44 mm limit outlined in the NIJ Standard. While initial kinetic energy absorption is independent of the insert’s thickness, the composite structure’s transverse stiffness drives subsequent deformation of the textile backing. Increasing the composite plies from 8 to 20 reduced maximum BFS from ~33 mm to ~20 mm, transforming the fabric’s deformation profile from steep and localized to flat and widely distributed.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.