Abstract
This study presents the results and analysis of the structural, thermal, and magnetic studies of the Fe3Sn system when Sn is replaced by Si. Fe3Sn is a potential material for obtaining permanent magnets free of rare earths. Fe3Sn1−xSix samples with x = 0.00, 0.05, 0.10, 0.15, and 0.20 were prepared via solid-state reactions. The experimental techniques used for the characterization were vibrating sample magnetometry (VSM), X-ray diffraction (XRD), Mössbauer spectrometry (MS), and magnetic thermogravimetric analysis (MTGA). The VSM analysis showed that all samples were magnetically soft, with the highest values of saturation magnetization Ms = 133.62 Am2/kg and the anisotropy constant K1 = 2.09 MJ/m3 for the sample x = 0.20. The X-ray patterns of the samples were refined with a hexagonal Fe3Sn phase and two cubic phases, Si0.95Fe0.05 and Fe1.84Sn0.16, in the latter, the Fe is surrounded by two distinct Sn environments. From the results obtained, it can be concluded that the solubility of Si in the Fe3Sn matrix is at some concentration in the range between 10 and 15%, and at 15% the excess of Si contributes to the segregation of the Si0.95Fe0.05 phase. Using the MOSFIT program, the Mössbauer spectra were fitted with three sextets and a doublet associated with the Fe3Sn, Fe1.84Sn0.16 (in the latter, Fe is surrounded by different Sn environments) and Si0.95Fe0.05 phases, respectively. Thermogravimetric analysis showed that the samples had two magnetic transitions associated with the Fe3Sn and Fe1.84Sn0.16 phases, respectively, which coincided with the fitting results obtained from the Mössbauer spectra.