Skip to Content
  • Proceeding Paper
  • Open Access

17 November 2026

17 Pages

Underutilised Sudanese Hardwood Species as Sustainable Construction Materials: An Engineering Assessment of the Property Record †

Institute of Applied Sciences, Faculty of Wood Engineering and Creative Industries, University of Sopron, 9400 Sopron, Hungary
†
Presented at the 5th International Electronic Conference on Forests (IECF 2026), 14–16 September 2026; Available online: https://sciforum.net/event/IECF2026.

Abstract

Sudan holds roughly 29.8 million ha of forest and 24.9 million ha of other wooded land, and these resources are used overwhelmingly for energy rather than for construction. This paper is a critical assessment of the published wood-property record for eight Sudanese hardwood species—Anogeissus leiocarpus, Balanites aegyptiaca, Acacia nilotica, Khaya senegalensis, Eucalyptus camaldulensis, Azadirachta indica, Sclerocarya birrea and Commiphora africana—and of what that record does, and does not, support for structural timber and engineered wood products. No new experimental work is reported: all values are taken from the published literature, every value is printed with its source and the type of that source is named, and values that could not be traced to an identified study or a verifiable database entry were withdrawn rather than reproduced. Three species carry a strength class assigned in a primary Sudanese study, but from small clear specimens rather than the structural-size members EN 384 presupposes, and for one of the three the stiffness in the record is about 30% below the mean modulus of elasticity that the assigned class requires. For Khaya senegalensis and Azadirachta indica, no Sudanese measurement of density or strength was traced; values exist only for material grown elsewhere in Africa and are reported here as such. Natural durability has not been determined on Sudanese material for any of the eight species. A second constraint is regulatory rather than material: the EN 338 C-classes, EN 14080 and ANSI/APA PRG 320 are written for softwoods, so hardwood products are routed instead through EN 16737 visual grading, EN 384 testing and European Assessment Documents. The binding constraints on structural use are therefore the absence of characteristic values, of accredited testing, and of kiln drying, not the timber itself.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.