Skip to Content
Materials ProceedingsMaterials Proceedings
  • Proceeding Paper
  • Open Access

18 February 2021

7 Pages

Effect of Initial Microstructure on Soft Annealing of a Low-Carbon Bainitic Steel †

,
,
,
,
,
and
1
School of Material Science and Engineering, Harbin Institute of Technology, Harbin 150001, China
2
School of Material Science and Engineering, Harbin University of Science and Technology, Harbin 150040, China
*
Author to whom correspondence should be addressed.
†
Presented at the 1st International Electronic Conference on Metallurgy and Metals, 22 February–7 March 2021. Available online: https://iec2m.sciforum.net/.

Abstract

A low-carbon bainitic tool steel exhibiting high hardness after hot rolling typically has poor machinability. To soften this type of steel and to accelerate the soft annealing process, an austenitizing step was designed based on thermodynamic calculations of phase stability and introduced prior to the annealing step. Different initial microstructures were prepared by three austenitizing temperatures (680 °C, 850 °C, 1000 °C) and three cooling methods (water quenching, oil quenching, and air cooling). The effect of initial microstructure on microstructures and hardness was studied. Softening equations, a function of annealing temperature and time, were established for different initial microstructures, and the relationships between annealing temperature, annealing time, activation energy, and hardness were explored. The predicted hardness was consistent with the measured values. Martensitic structure has a low activation energy for diffusion and a higher softening rate compared to that of the bainitic structure. In addition, the higher the carbide content in the bainitic structure, the smaller the activation energy tended to be.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.