Skip to Content
You are currently on the new version of our website. Access the old version .
  • Proceeding Paper
  • Open Access

23 September 2022

5 Pages

Cellulose Triacetate/Zinc Oxide Membrane for Bioethanol Recovery via Pervaporation †

,
,
,
and
1
Department of Mechanical Engineering, Faculty of Mechanical and Aeronautical Engineering, University of Engineering and Technology, Taxila 47080, Pakistan
2
Department of Physics, College of Science, Jouf University, Sakaka 72388, Saudi Arabia
3
Department of Chemical Engineering Technology, Faculty of Engineering, Government College University, Faisalabad 38000, Pakistan
4
Department of Metallurgy and Materials Engineering, Faculty of Mechanical and Aeronautical Engineering, University of Engineering and Technology, Taxila 47080, Pakistan

Abstract

In this study, cellulose triacetate (CTA) hybrid membrane is successfully prepared via the phase-inversion method for bioethanol recovery through pervaporation. Nano zinc oxide (ZnO) particles are mixed into the polymer matrices of CTA to enhance the pervaporation membrane’s performance. The fabricated hybrid membrane is characterized using environmental scanning electron microscopy (ESEM) and thermogravimetric analysis (TGA) to reveal the surface morphology and thermal resistance, respectively. The pervaporation performance of the hybrid membrane is assessed for recovering bioethanol from its dilute solution. Pervaporation results show that the hybrid membrane prepared with 3 wt.% ZnO achieved a permeation flux of 1065.71 g/m2h, while the separation factor was around 1038 at 50 °C operating temperature.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.