Skip to Content
You are currently on the new version of our website. Access the old version .
FluidsFluids
  • Article
  • Open Access

24 November 2022

16 Pages

Tribological Performance for Steel–Steel Contact Interfaces Using Hybrid MWCNTs/Al2O3 Nanoparticles as Oil-Based Additives in Engines

,
,
,
and
1
Production Engineering and Mechanical Design, Faculty of Engineering, Minia University, El-Minia 61111, Egypt
2
Mechanical Engineering Department, College of Engineering and Technology, Arab Academy for Science, Technology and Maritime Transport, Sadat Road, P.O. Box 11, Aswan 81511, Egypt
3
Cellulose and Paper Department, National Research Centre, 33 El-Buhouth Street, Dokki, Giza 12622, Egypt
4
NanoStruc Research Group, Chemistry Department, Faculty of Science, Helwan University, Cairo 11795, Egypt

Abstract

Numerous problems occur during engine operation, such as start-up, lack of lubrication, and overheating, resulting in engine components’ wear, power loss, and fuel consumption. Nanomaterials dispersed in engine oil can play an important role in improving the tribological properties of oil lubricants. This study investigated the influence of multi-walled carbon nanotubes (MWCNTs) and aluminum oxide nanoparticles (Al2O3 NPs) as nano-additives for lubricants. Different engine oil samples were loaded with 0.5–2.0 wt% Al2O3 NPs and 0.5–1.0 wt% MWCNTs and compared with unmodified oil. The tribological performance of the nano lubricants was investigated using the four-ball test method. In addition, the wear scar in the engine was evaluated using 3D micrographs and scanning electron microscopy (SEM). The results of the sliding surfaces with hybrid MWCNTs/Al2O3 NPs showed better friction performance and wear resistance. The coefficient of friction (COF) and wear scar width were improved by 47.9% and 51.5%, respectively, compared with unmodified oil.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.