Abstract
Biomimetic surface textures can reduce hydrodynamic drag without changing the hull shape. This study examines round pits inspired by those on the head of the dung beetle, applied to the head or the tail of a 1:10-scale DARPA SUBOFF bare hull (L = 435.6 mm, D = 50.8 mm). Steady RANS (SST k–ω) simulations were performed at Re = 1.4 × 106 and 2.9 × 106, after validation against towing-tank drag measurements on the full-size smooth hull. The pit diameter (d/D = 0.020–0.098, h/d = 0.4–1.5), number of rows (up to 13) and circumferential spacing (100–25°) were varied one at a time. The best tail array (11 rows, d = 2 mm, 15°, x/L = 0.86) and head array (5 rows, d = 1.5 mm, 15°, x/L = 0.18) reduced the total drag by 9.4% and 10.4% (±1.7 percentage points) at Re = 2.9 × 106 and by 12.8% and 9.8% at Re = 1.4 × 106. The reductions came from the pressure drag (−34.0% and −36.4%), which outweighed a small rise in skin friction (+2.6% and +2.3%). With 12 or 13 rows, the drag rose 2.8% above the smooth hull, and tail pits larger than 2 mm gave smaller reductions. On the tail, the reductions at the two Reynolds numbers collapsed on the pit diameter relative to the boundary-layer thickness, with the largest at d/δ ≈ 0.25, but not on the diameter in wall units. When the head section was considered, they mainly depended on the station. Within the limits of steady RANS, the results identify promising pit configurations at the model scale, which scale-resolving simulations and experiments should confirm.