Skip to Content
ProcessesProcesses
  • Article
  • Open Access

20 November 2026

21 Pages

Effect of Bottom Geometry on the Hydrodynamic Behavior of a Stirred Tank

,
,
,
,
and
1
Secretaría de Ciencia, Humanidades, Tecnología e Innovación—Universidad Autónoma Metropolitana Azcapotzalco, Av. San Pablo 420, Col. Nueva El Rosario, Alcaldía Azcapotzalco, Ciudad de México C.P. 02128, Mexico
2
Departamento de Ciencias Básicas, Universidad Autónoma Metropolitana Azcapotzalco, Av. San Pablo 420, Col. Nueva El Rosario, Alcaldía Azcapotzalco, Ciudad de México C.P. 02128, Mexico
3
Secretaría de Ciencia, Humanidades, Tecnología e Innovación—Departamento de Ingeniería Civil y Ambiental, Universidad de Guanajuato, Av. Juárez No. 77, Zona Centro, Guanajuato C.P. 36000, Gto, Mexico
4
División de Ingeniería Química y Bioquímica—Tecnológico Nacional de México – Tecnológico de Estudios Superiores de Ecatepec, Av. Tecnológico S/N, Col. Valle de Anáhuac, Ecatepec de Morelos C.P. 55210, Mexico

Abstract

Stirred tanks are widely used throughout the process industry. While extensive efforts have been made to improve their operational efficiency—primarily through the design of novel impellers—modifications to the underlying tank geometry remain underexplored. Previous geometric studies have predominantly examined rectangular tanks or minor bottom profile adjustments; however, systematic evaluations of specific profile modifications remain scarce. Consequently, this study focuses on the tank bottom profile by introducing corner curvature radii (ranging from 15 mm to 120 mm) and systematically evaluating their effect on the reactor’s hydrodynamic performance. The investigation was conducted using computational fluid dynamics, and the numerical data were validated against particle image velocimetry measurements. The results demonstrate that the tank bottom radius significantly alters the lateral recirculation loops, expanding them vertically by up to 22% relative to the flat-bottom baseline. Additionally, the modified profile induces a velocity increase of up to 6% in the x-y plane. Turbulent kinetic energy rises by up to 5.5% in the x-y plane and by 59% within the bulk zone of the x-z plane relative to the flat-bottom baseline. Concurrently, the turbulent kinetic energy dissipation rate decreases by up to 12% in the x-y plane, yet exhibits a 43% increase within the bulk zone of the x-z plane relative to the flat-bottom baseline. Ultimately, these findings demonstrate that global hydrodynamic behavior can be substantially tailored through targeted modifications to the tank bottom profile.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.