Skip to Content
AerospaceAerospace
  • Article
  • Open Access

28 September 2026

18 Pages

Flow Control of NACA Flush Inlet Based on Vane Vortex Generators

,
,
,
and
1
Aviation Industry Corporation of China The First Aircraft Institute, Xi’an 710089, China
2
School of Aeronautics, Northwestern Polytechnical University, Xi’an 710072, China
3
National Key Laboratory of Aircraft Configuration Design, Xi’an 710072, China
*
Author to whom correspondence should be addressed.

Abstract

NACA flush inlets exhibit favorable low-drag performance, yet they suffer from low total pressure recovery and high flow distortion, which limit their widespread application. To address these issues, a passive flow control method using vane vortex generators (VVGs) is proposed for NACA-type inlets. First, CFD numerical simulations are conducted to analyze the inlet flow field characteristics and elaborate the design principle of VVGs. Next, orthogonal tests are performed to comprehensively investigate the effects of VVG parameters on the flow field of the NACA flush inlet. Finally, the aerodynamic coupling mechanism between VVGs and the NACA flush inlet is explored in depth through analysis of limiting streamlines, total pressure recovery distribution, Mach number distribution and swirl angle distribution. The results show that VVGs optimize the distribution of low-momentum airflow inside the inlet via flow guidance. The micro vortices generated by VVGs enhance mixing between low-energy and high-energy airflow within the boundary layer, thereby suppressing flow separation in the duct. Compared with the baseline configuration, the maximum reduction in the total pressure distortion index (DC60) for the controlled configuration is approximately 55%.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.