Next Article in Journal
Effect of Aluminum Flakes on Corrosion Protection Behavior of Water-Based Hybrid Zinc-Rich Coatings for Carbon Steel Substrate in NaCl Environment
Next Article in Special Issue
Microstructural Properties of Particle-Reinforced Multilayer Systems of 316L and 430L Alloys on Gray Cast Iron
Previous Article in Journal
Kinetics and Mechanical Characterization of Hard Layers Obtained by Boron Diffusion in 80/20 Nickel–Chromium Alloy
 
 
Article
Peer-Review Record

Microstructure, Wear and Corrosion Behaviors of Electrodeposited Ni-Diamond Micro-Composite Coatings

Coatings 2022, 12(10), 1391; https://doi.org/10.3390/coatings12101391
by Xiaoli Wang 1,*, Ziyi Zhao 1, Jinsong Chen 2, Xin Zhou 1 and Yinjie Zong 1
Reviewer 1:
Reviewer 2:
Coatings 2022, 12(10), 1391; https://doi.org/10.3390/coatings12101391
Submission received: 5 September 2022 / Revised: 18 September 2022 / Accepted: 19 September 2022 / Published: 23 September 2022
(This article belongs to the Special Issue Wear-Resistance and Corrosion-Resistance Coatings)

Round 1

Reviewer 1 Report

The study described in the article and devoted to the analysis of the microstructure and properties of electroplated Ni-diamond coatings is of little originality and is of little interest to the reader. According to the research presented by the author of the article, a lot of work has been done, for example, the following are known: M. Wang, Preparation of Ni-diamond composite coating by composite electroplating. Journal of Central South University (Science and Technology) 44(7):2688-2695. 2013. Xiangzhu He, Preparation and Investigation of Ni-Diamond Composite Coatings by Electrodeposition. Nanoscience and Nanotechnology Letters 4(1):48-52, 2012. E.C. Lee, A study on the mechanism of formation of electrocodeposited Ni–diamond coatings, 2001 and others.

 There are a number of comments on the article:

1. Specify clearly at the end of paragraph "1 Introduction", the purpose of the work. Then there are the research questions.

2. In the text of the article, it is necessary to clearly state for what it is necessary to perform this work.

3. In the introduction, indicate links to the works presented by me. What is new in the article in comparison with the studies already performed (M. Wang, Preparation of Ni-diamond composite coating by composite electroplating. Journal of Central South University (Science and Technology) 44(7):2688-2695. 2013. Xiangzhu He, Preparation and Investigation of Ni-Diamond Composite Coatings by Electrodeposition. Nanoscience and Nanotechnology Letters 4(1):48-52, 2012. E.C. Lee, A study on the mechanism of formation of electrocodeposited Ni–diamond coatings, 2001).

4. Due to which the coefficient of friction in nickel-diamond coatings is reduced, provide a scientific justification.

Author Response

Please see the attachment.

Author Response File: Author Response.doc

Reviewer 2 Report

Please see the enclosed file for suggestions.

Comments for author File: Comments.docx

Author Response

Please see the attachment

Author Response File: Author Response.doc

Round 2

Reviewer 1 Report

I received responses to comments.

Back to TopTop