Skip to Content
NanomaterialsNanomaterials
  • Article
  • Open Access

19 November 2026

16 Pages

Green Synthesis and Characterization of Copper and Copper/Zinc Nanoparticles Using Moringa oleifera Lam. Extract

,
,
,
,
,
,
,
,
…
1
Postgraduate Program in Phytotechnics, Federal Rural University of the Semi-Arid Region, Mossoró 59625-900, Brazil
2
Postgraduate Program in Soil and Water Management, Federal Rural University of the Semi-Arid Region, Mossoró 59625-900, Brazil
3
Department of Agronomic and Forest Sciences, Federal Rural University of the Semi-Arid Region, Mossoró 59625-900, Brazil
4
Academic Unit of Serra Talhada (UAST), Federal Rural University of Pernambuco, Serra Talhada 56909-535, Brazil
This article belongs to the Section Nanotechnology in Agriculture

Abstract

The green synthesis of metallic nanoparticles using plant extracts has been investigated as an alternative to conventional chemical routes. In this study, copper-containing nanoparticles (CuNPs) and copper- and zinc-containing nanoparticles (CuZnNPs) were synthesized by adding an aqueous leaf decoction of Moringa oleifera Lam. to precursor solutions of CuSO4 (CuNPs) or CuSO4 and ZnSO4 (CuZnNPs). The materials were characterized by field-emission gun scanning electron microscopy (FEG-SEM), energy-dispersive X-ray spectroscopy (EDS), energy-dispersive X-ray fluorescence (EDXRF), inductively coupled plasma optical emission spectrometry (ICP-OES), ultraviolet–visible (UV-Vis) spectroscopy, Fourier-transform infrared (FTIR) spectroscopy, and X-ray diffraction (XRD). FEG-SEM revealed spherical to ellipsoidal particle mean diameters of 493 ± 118 nm (CuNPs) and 400 ± 139 (CuZnNPs). The UV-Vis spectra showed no well-defined surface plasmon resonance band. The Cu:Zn ratio in the CuZnNPs (≈1.2:1 by EDS; ≈1.1:1 by EDXRF and ICP-OES) was consistent with the precursor ratio. ICP-OES indicated total metal contents below 1 wt% (9933 mg kg−1 Cu in CuNPs; 4411 mg kg−1 Cu and 4018.5 mg kg−1 Zn in CuZnNPs), values substantially lower than those obtained by EDS and EDXRF. These two techniques also detected high sulfur contents, with S/(Cu + Zn) molar ratios close to 1. FTIR bands at 1060–1100, 1020, and 660 cm−1, which were absent from the decoction spectrum, were consistent with residual sulfate from the precursors. Overall, these results describe the composition and morphology of the materials obtained, but phase identification, colloidal behavior, and agricultural performance remain unconfirmed and require further investigation.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.