Skip to Content
NanomaterialsNanomaterials
  • Review
  • Open Access

18 November 2026

61 Pages

Plasmonic Polymer Nanocomposites for Sensing and Imaging Applications

,
,
,
and
1
Physics of Polymers and Polymeric Materials, “Petru Poni” Institute of Macromolecular Chemistry, 41A Grigore Ghica Vodă Alley, 700487 Iași, Romania
2
Nanotechnology Laboratory, TRANSCEND Research Center, Regional Institute of Oncology, 2–4 General Henri Mathias Berthelot Street, 700483 Iași, Romania
3
Faculty of Chemistry, “Alexandru Ioan Cuza” University of Iași, 11 Carol I Boulevard, 700506 Iași, Romania
4
Department of NanoSciences, Institute of Biomedical Research-MedFUTURE, “Iuliu Hațieganu” University of Medicine and Pharmacy, 4–6 Pasteur Street, 400349 Cluj-Napoca, Romania

Abstract

Polymer-metal nanocomposites couple nanoparticle optical properties with matrix-dependent organisation, transport, and mechanical behaviour. This narrative critical review examines how films, hydrogels, microgels, electrospun fibres, conducting polymers, and polymer coatings influence localised surface plasmon resonance, surface-enhanced Raman scattering (SERS), metal-enhanced fluorescence (MEF), electrochemical sensing, and imaging. The analysis distinguishes measured analytical outcomes from proposed mechanisms and identifies the controls needed to isolate polymer contributions. Reported performance depends on analyte deposition, nanoparticle geometry, excitation conditions, and the definition of enhancement. For example, PMMA-coated Au@Ag nanorod arrays show approximately 27-fold fluorescence enhancement at a metal-dye separation of 16 nm, whereas a single-particle Ag/polymer measurement gives a lower-bound enhancement of 26-fold against a different reference. These values illustrate the importance of geometric and reference definitions without establishing an architecture ranking. Au- and Ag-containing conducting-polymer electrodes are considered separately because improved electrochemical response does not itself demonstrate plasmon excitation. The main unresolved needs are consistent enhancement-factor reporting, polymer-only and metal-only controls, measured transport and swelling parameters, stability under realistic operating conditions, and validation in complex samples. Imaging is evaluated as a complementary application with formulation-specific biological evidence. The resulting framework connects polymer design choices to demonstrated benefits, competing effects, and limits of comparison.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.