In the original publication [1], there was a mistake in Figure 4 as published. Three sub-pictures (Figure 4b–d) were the same in Figure 4. The corrected Figure 4 appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Figure 4.
Microstructures of the tested samples: (a) cast sample; image plane parallel to rod axis (100× magnification); (b) cast sample; image plane perpendicular to rod axis (500× magnification); (c) SLM sample; image plane parallel to rod axis (100× magnification); (d) SLM sample; image plane perpendicular to rod axis (500× magnification). Example pores are marked with arrows.
Reference
- Klimek, L.; Bułhak, B.; Śmielak, B. A Comparison of the Structure and Selected Mechanical Properties of Cr/Co Alloys Obtained by Casting and Selective Laser Melting. J. Funct. Biomater. 2024, 15, 61. [Google Scholar] [CrossRef]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2024 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).