Skip to Content
  • Article
  • Open Access

27 February 2026

27 Pages

Analysis and Experimental Study of Deep-Sea Drilling Sampling Stratification Based on DEM Theory

,
,
,
and
1
National Deep Sea Center, Qingdao 266237, China
2
College of Marine Science and Engineering, Shandong University of Science and Technology, Qingdao 266590, China
3
Laoshan Laboratory, Qingdao 266237, China
*
Author to whom correspondence should be addressed.
This article belongs to the Section Ocean Engineering

Abstract

Under extreme heterogeneous loading conditions in the deep sea, obtaining well-preserved and stratigraphically coherent cores is a critical challenge that requires urgent resolution. Current methods cannot directly determine the preservation of core stratigraphic information or the sampling behaviour of drill bits through experimentation. Consequently, a new evaluation method for angular velocity-based stratigraphic preservation, which is grounded in Discrete Element Method (DEM) theory, is proposed. Simulation modelling uses the Hertz–Mindlin contact model to construct a multi-scale geotechnical–drill string numerical coupling model. The drill string structure is simplified while incorporating actual geometric dimensions and material properties. By simulating and extracting particle angular velocity data under various operating conditions, a correlation is established between particle motion characteristics and the stratigraphic preservation status. Experiments were conducted on a customised drilling rig platform using specimens with deep-sea geomechanical properties consistent with the simulations. Drilling tools with multiple inner diameter specifications were configured, and multiple variable combinations of the rotational speed and feed rate were set. The degree of bedding preservation in the sampled cores was recorded synchronously. The study clarified the relationship between particle angular velocity and bedding preservation, identifying the influence patterns of parameters such as the tool inner diameter, rotational speed, and feed rate on bedding preservation. Results indicate that when the rotational speed exceeds 200 rpm and the feed rate falls below 0.018 m/s, stratigraphic distortion significantly increases; the drill bit inner diameter exhibits a non-linear negative correlation with core disturbance. This study provides theoretical underpinnings and experimental evidence for multi-parameter process optimisation in maintaining stratigraphic integrity during deep-sea submersible coring operations.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.