Skip to Content
Applied SciencesApplied Sciences
  • Article
  • Open Access

12 September 2020

11 Pages

Enhancement of Visible-Light Photocatalytic Efficiency of TiO2 Nanopowder by Anatase/Rutile Dual Phase Formation

and
1
Department of Materials Science and Engineering, National Dong Hwa University, 1, Sec. 2, Da Hsueh Rd., Shoufeng, Hualien 97401, Taiwan
2
Department of Optoel-ectronic Engineering, National Dong Hwa University, 1, Sec. 2, Da Hsueh Rd., Shoufeng, Hualien 97401, Taiwan
*
Author to whom correspondence should be addressed.

Abstract

Visible-light photocatalytically active titanium oxide (TiO2) nano-powder was synthesized by a flat-flame chemical vapor condensation method. The formation of TiO2 consisting of different ratios of anatase and rutile phases was controlled by two parameters: the acetylene flow rate (C2H2, 600 sccm and 800 sccm) and the acetylene/oxygen flow ratio (C2H2/O2, 1:3, 1:4, 1:5, and 1:6). The location of the photonic center was identified for visible-light absorption, which is in the anatase grains. The photonic center on the surface of anatase grains happens to be the nucleation site for rutile in an oxygen-deficient environment. The visible-light absorption could be attributed to the formation of defect levels related to the photonic center within the band gap of anatase. The major role of the mixed-phase structure of TiO2 in the enhancement of visible-light photocatalytic activity is in the enhancement of carrier separation and not of light harvest, for the powder produced in this study.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.