Skip to Content
You are currently on the new version of our website. Access the old version .
MetalsMetals
  • Article
  • Open Access

28 November 2019

12 Pages

Effect of Cutting Crystal Directions on Micro-Defect Evolution of Single Crystal γ-TiAl Alloy with Molecular Dynamics Simulation

,
,
,
,
,
and
1
School of Mechanical and Electrical Engineering, Lanzhou University of Technology, Lanzhou 730050, China
2
Key Laboratory of Digital Manufacturing Technology and Application, Ministry of Education, Lanzhou University of Technology, Lanzhou 730050, China
3
Centre for Efficiency and Performance Engineering, University of Huddersfield, Huddersfield HD1 3DH, UK
*
Authors to whom correspondence should be addressed.

Abstract

In this work, the distribution and evolution of micro-defect in single crystal γ-TiAl alloy during nanometer cutting is studied by means of molecular dynamics simulation. Nanometer cutting is performed along two typical crystal directions: [ 1 ¯ 00 ] and [ 1 ¯ 01 ] . A machined surface, system potential energy, amorphous layer, lattice deformation and the formation mechanism of chip are discussed. The results indicate that the intrinsic stacking fault, dislocation loop and atomic cluster are generated below the machined surface along the cutting crystal directions. In particular, the Stacking Fault Tetrahedron (SFT) is generated inside the workpiece when the cutting crystal direction is along [ 1 ¯ 00 ] . However, a “V”-shape dislocation loop is formed in the workpiece along [ 1 ¯ 01 ] . Furthermore, atomic distribution of the machined surface indicates that the surface quality along [ 1 ¯ 00 ] is better than that along [ 1 ¯ 01 ] . In a certain range, the thickness of the amorphous layer increases gradually with the rise of cutting force during nanometric cutting process.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.