Skip to Content
MetalsMetals
  • Article
  • Open Access

11 July 2026

15 Pages

High-Temperature Deformation Behavior of Ti-55531 Alloy with a Lamellar Microstructure

,
,
and
State Key Laboratory for Advanced Metals and Materials, University of Science and Technology Beijing, Beijing 100083, China
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Advances in Lightweight Alloys, 3rd Edition

Abstract

The macroscopic mechanical properties of near-β titanium alloys depend inherently on their complex microstructural morphologies and phase transformation kinetics. This study investigates the deformation behavior of a lamellar Ti-55531 alloy during isothermal compression and in situ tensile testing. Pronounced strain rate sensitivity dictates the deformation of the lamellar microstructure. Low strain rate deformation (0.001 s−1) induces dynamic recovery and recrystallization, which in turn drive α-lamellae fragmentation and the nucleation of new α phase during compression. The α precipitation is governed by a strict Burgers orientation relationship (BOR), but extensive plastic deformation may lead to the breakdown of the BOR. During tension, continuous slip transfer between adjacent phases is critically restricted by α/β interfacial thickness. As plastic strain accumulates, lath-like, V-shaped, and acicular α phases precipitate concurrently within β grains, creating a complex α microstructure.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.