Skip to Content
You are currently on the new version of our website. Access the old version .
MetalsMetals
  • Article
  • Open Access

26 November 2024

11 Pages

Investigation of Ti0.92+xZr0.1−xCr1.0Mn0.6Fe0.4 Alloys for Use as 25 MPa Hydrogen Compression Materials

,
,
,
,
,
and
1
College of Chemistry and Chemical Engineering, Henan Polytechnic University, Jiaozuo 454000, China
2
State Collaborative Innovation Center of Coal Work Safety and Clean-Efficiency Utilization, Jiaozuo 454003, China
*
Authors to whom correspondence should be addressed.

Abstract

Metal hydride hydrogen compressors have attracted great attention due to their reliable safety, environmental friendliness, and the absence of vibration and noise. Herein, the effects of Ti substitution for Zr on the crystal structure and hydrogen compressive performance of Ti0.92+xZr0.1−xCr1.0Mn0.6Fe0.4 (x = 0, 0.01, 0.02, and 0.03) are investigated systematically. Among the investigated alloys, the Ti0.94Zr0.08Cr1.0Mn0.6Fe0.4 alloy can be considered as a promising candidate for application with a hydrogen capacity of 1.67 wt.% under 8 MPa at 10 °C. Additionally, it exhibits excellent cyclic stability. The desorption pressure at 83.9 °C was determined to be 25 MPa by van’t Hoff fitting plots, which fulfills the requirement of producing over 25 MPa hydrogen pressure in water-bath environments with a high compression ratio of 3.08. The Ti0.94Zr0.08Cr1.0Mn0.6Fe0.4 alloy is very promising for hydrogen refueling applications in long-tube trailers and low-pressure gas cylinders.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.