Skip to Content
LubricantsLubricants
  • Article
  • Open Access

20 November 2026

15 Pages

A General Finite-Width Model for the eX-Poro-Hydrodynamic (XPHD) Inclined Slider: Theory and Experimental Validation

,
and
1
Faculty of Engineering Mechanics and Automation, University of Engineering and Technology, Vietnam National University, Hanoi 100000, Vietnam
2
School of Information and Electronic Engineering, Zhejiang Gongshang University, Hangzhou 310018, China
*
Author to whom correspondence should be addressed.
Lubricants2026, 14(11), 447;https://doi.org/10.3390/lubricants14110447 
(registering DOI)

Abstract

Pascovici’s one-dimensional (1D) eX-poro-hydrodynamic (XPHD) model for an inclined slider was recently validated experimentally at low sliding speed using a water-imbibed woven porous layer. A 1D model, however, cannot predict side leakage from a real pad of finite width. This paper extends the model to finite width within the same framework: Darcy flow through a porous layer sliding beneath a stationary pad with porosity set by compression and permeability given by a Carman–Kozeny law with a single empirical constant. No free parameter is added. We show analytically, and with an independently coded finite-difference solver, that the resulting equation reduces exactly to the published 1D result as the pad width grows; the numerical solution converges to within 0.01% at large width-to-length ratio W/L. Compared with published measurements for two pad widths and three compression levels, the model gives acceptable predictions without any fitted parameter. It captures the wide-pad peak pressure to within about 10%, with typical differences of 14–19% of the measured peak, which is an offset consistent with the uncertainty of the independently measured permeability. The model over-predicts the pressure reduction for the narrower pad (narrow-to-wide peak ratio 0.62 vs. 0.73); a sensitivity analysis shows that this can be explained either by a moderate in-plane anisotropy of the textile or by a compressed footprint extending a few millimeters beyond the side edges of the pad. To the authors’ knowledge, this is the first test of a finite-width XPHD-type model against a liquid-imbibed textile with pad width comparable to its length (W/L ≈ 0.5−2).

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.