Skip to Content
MachinesMachines
  • Article
  • Open Access

21 September 2026

24 Pages

Design and Experimental Validation of a Programmable Pressure Pneumatic Knife CNC Platform for Flexible Sheet Cutting

,
,
,
and
1
Department of Mechanical Engineering, Faculty of Engineering, Chulalongkorn University, Bangkok 10330, Thailand
2
Center of Excellence for Human-Robot Collaboration and Systems Integration, Chulalongkorn University, Bangkok 10330, Thailand
*
Author to whom correspondence should be addressed.

Abstract

This study presents a programmable pressure pneumatic knife CNC platform for the fabrication and experimental investigation of flexible sheet materials. The platform enables independent control of blade-loading pressure, feed rate, and toolpath motion, allowing pressure–feed rate operating windows for mechanical knife cutting to be established. Paper and vinyl sheets are evaluated using square and straight-line cutting patterns, with cutting quality classified into four regimes: clean cut, skimming, tearing, and crushing. The results demonstrate that insufficient pressure causes unstable blade–material contact, resulting in skimming or no-touch behavior, whereas excessive pressure promotes tearing. Paper attains a 99% clean cut rate at 1 bar and 9000 mm min−1 during square cutting, while vinyl exhibits 100% clean cuts across 3000 mm min−1 to 9000 mm min−1 at 3 bar. Straight-line cutting achieves clean cut rates of 98% for paper and 97% for vinyl at 2 bar and 7000 mm min−1. These findings support the effectiveness of programmable pressure mechanical knife cutting for repeatable fabrication of flexible sheet materials.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.