Skip to Content
WaterWater
  • Article
  • Open Access

18 November 2026

29 Pages

Apparent Fracture Conductivity and Hydraulic Resistance During Water–Shale Interaction Under Anisotropic Stress and Different Initial Thermal Histories

and
1
School of Resources and Geosciences, China University of Mining & Technology, No. 1 Daxue Road, Xuzhou 221116, China
2
School of Mines, China University of Mining & Technology, No. 1 Daxue Road, Xuzhou 221116, China
*
Author to whom correspondence should be addressed.
This article belongs to the Section Hydrogeology

Abstract

Flow through unpropped shale fractures evolves under the influence of water–shale interaction. Seven Mancos shale cores were investigated under anisotropic compression. Four fractured samples were used to conduct the flow-through tests at 2 mL/min for 178–240 h, at differential stresses of 5.2 or 15.5 MPa and initial temperatures of 18.5 or 80 °C. Three cavity samples were exposed to the same fluid at a constant injection pressure of 2 MPa for 48 h. Results of flow-through tests show that the apparent fracture-conductivity indices for MAN-2 and MAN-4 decreased by approximately 77% and 75%, respectively, between 12 and 240 h after injection began, with significant attenuation observed within the first 48 h at the initial temperature of 18.5 °C. MAN-1, initially conditioned at 80 °C, fragmented near 170 h; by 177.8 h, the cumulative pressure decline corresponded to an approximately 90.6% reduction in system hydraulic resistance at the maintained injection rate. This temporal association does not establish thermal pretreatment as the cause of failure. Previous reports indicate that the count of image components associated with micro-fractures is 414 for MAN-3 and 290 for MAN-4. In a sensitivity analysis based on a standardized workflow, 14 out of 15 parameter configurations yielded higher values for MAN-3 than for MAN-4; under the most stringent parameter configuration, both values were zero, with no instances of reversal observed. Results of three cavity samples show that the cavity-area coefficients of variation were 4.0% to 7.7%, without coherent progressive damage. The results indicate that local damage does not ensure improved through-flow, and major hydraulic reorganization could be delayed beyond 48 h. In addition, the sample that was initially at high temperatures exhibited more pronounced damage; however, due to the cooling process and variations in the initial fracture state of each specimen, it is not possible to quantify the independent contribution of thermal effects.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.