Skip to Content
PolymersPolymers
  • Article
  • Open Access

14 December 2024

16 Pages

The Design of a Controlled-Release Polymer of a Phytopharmaceutical Agent: A Study on the Release in Different PH Environments Using the Ultrafiltration Technique

,
,
,
and
1
Departamento de Química, Facultad de Ciencias Naturales, Matemáticas y Medio Ambiente, Universidad Tecnológica Metropolitana (UTEM), J. P. Alessandri 1242, Santiago 7800002, Chile
2
Departamento de Química Física, Facultad de Química y de Farmacia, Pontificia Universidad Católica de Chile, Santiago 7820436, Chile
3
Departamento de Química de los Materiales, Facultad de Química y Biología, Universidad de Santiago de Chile (USACH), Santiago 9170002, Chile
4
Departamento de Química Orgánica, Facultad de Química y de Farmacia, Pontificia Universidad Católica de Chile, Santiago 7820436, Chile

Abstract

A series of hydrophilic copolymers were prepared using 2-hydroxyethyl methacrylate (HEMA) and itaconic acid (IA) from free radical polymerization at different feed monomer ratios using ammonium persulfate (APS) initiators in water at 70 °C. The herbicide 2,4-dichlorophenoxy acetic acid (2,4-D) was grafted to Poly(HEMA-co-IA) by a condensation reaction. The hydrolysis of the polymeric release system, Poly(HEMA-co-IA)-2,4-D, demonstrated that the release of the herbicide in an aqueous phase depends on the polymeric system’s pH value and hydrophilic character. In addition, the swelling behavior (Wt%) was studied at different pH values using Liquid-phase Polymer Retention (LPR) in an ultrafiltration system. The acid hydrolysis of the herbicide from the conjugates follows a first-order kinetic, showing higher kinetic constants as the pH increases. The base-catalyzed hydrolysis reaction of the herbicide follows a zero-order kinetic, where the basic medium acts as a catalyst, accelerating the release rate of the herbicide and showing higher kinetic constants as the pH increases. The differences in the release rates found for the hydrogel herbicide at different pH values can be correlated with the difference in their swelling capacity, where the release rate generally increases with an increase in the swelling capacity from water solution at higher pH values. The study of the release process revealed that all samples in distilled water at a pH of 10 are representative of agricultural systems. It showed first-order swelling kinetics and an absorption capacity that conforms to the parameters for hydrogels for agricultural applications, which supports their potential for these purposes.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.