Skip to Content
CrystalsCrystals
  • Review
  • Open Access

18 November 2026

26 Pages

Exploiting the Electronic Properties of Carbon Nanotubes for Gas Sensing: Low-Power Memristor-Based Gas Sensors for Air-Quality Monitoring

and
Department of Semiconductor Systems Engineering, and Convergence Engineering for Intelligent Drone, Institute of Semiconductor and System IC, Sejong University, 209, Neungdong-Ro, Gwangjin-Gu, Seoul 05006, Republic of Korea
*
Author to whom correspondence should be addressed.

Abstract

Carbon nanotubes (CNTs) provide accessible surfaces and adsorption-sensitive electrical transport for gas sensing near ambient temperature. However, slow recovery, humidity interference, and limited selectivity constrain their practical use. This focused narrative review examines how CNT surface chemistry and device architecture influence these limitations, with particular emphasis on CNT sensors coupled to memristor heaters (MHs). Conventional material modification and external activation are compared with localized Joule heating associated with conductive filaments or nanoscale gaps in resistive-switching oxides. Selected MH-integrated devices report microwatt-level sensing power and millisecond-scale pulse-assisted baseline restoration, but these results depend on resistance state, bias protocol, and test conditions. We distinguish ambient temperature from local heater temperature, modeled mechanisms from direct observations, and device power from system-level energy consumption. Differences in response definitions, recovery criteria, and humidity protocols limit direct comparisons across studies. The review identifies the evidence needed to establish reproducible thermal control, selective detection in gas mixtures, and long-term operation for air-quality monitoring.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.