Correction: Martinez-Zuniga et al. Methyl Mercaptan Removal from Methane Using Metal-Oxides and Aluminosilicate Materials. Catalysts 2024, 14, 907

In the original publication [1], there was a mistake in the published version of Table 3. The composition of Select HP was removed from the table. The corrected version of

Table 3. Chemical composition of the 5 raw catalysts obtained by EDS analysis.

Compound [Mass%]	Select HP	CTG-ESG-011	Halloysites
			Pure	MinO	Mixed
Al	-	0.7	23.5	23.2	23.9
Si	-	0.5	26.1	24.5	29.6
Fe	-	45.3	12.5	12.9	11.8
Ca	-	3.4	0.2	0.7	0.8
Mg	-	1.8	0	0	0.4
K	-	0	0.2	0	0.7
Cl	-	1.9	0	0	0
Zn	-	0.7	0	0	0
Cu	-	0	0	0	0
Mn	-	0.2	0	7.6	1.7
O	-	45.5	37.5	31.1	31.1

appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.

There was an error in the original publication [1]. All references to the Select HP composition were removed, and Schlumberger was added as the manufacturer of Select HP.

A correction was made to Section 2.1.1, Paragraph 1; Section 2.3, Paragraph 1; Section 3.1, Paragraph 1; and Section 3.2, Paragraph 2.

In Section 2.1.1, Paragraph 1, the third sentence should be changed to the following:

Following closely behind was Select HP at 88.82 m²/g (manufactured by Schlumberger) and Halloysite MinO with a surface area of 85.5 m²/g.

In Section 2.3, Paragraph 1, the second sentence should be changed to the following:

The composition of Select HP, which is proprietary to Schlumberger CTG-ESC-011, contained a higher proportion of Fe.

In Section 3.1, Paragraph 1, the second sentence should be changed to the following:

To replicate Select HP, its elements were impregnated onto Halloysite Pure’s surface.

In Section 3.2, Paragraph 2, the eighth sentence should be changed to the following:

Select HP is composed of a mix of metal oxides.