Next Article in Journal
Heterogeneous Catalysts for the Conversion of Glucose into 5-Hydroxymethyl Furfural
Next Article in Special Issue
Plasma-Catalytic Process of Hydrogen Production from Mixture of Methanol and Water
Previous Article in Journal
An Investigation into the Bulk and Surface Phase Transformations of Bimetallic Pd-In/Al2O3 Catalyst during Reductive and Oxidative Treatments In Situ
Previous Article in Special Issue
Nonthermal Plasma Induced Fabrication of Solid Acid Catalysts for Glycerol Dehydration to Acrolein
 
 
Font Type:
Arial Georgia Verdana
Font Size:
Aa Aa Aa
Line Spacing:
Column Width:
Background:
Article

Decomposition of Tars on a Nickel Honeycomb Catalyst

by
Joanna Woroszył-Wojno
1,*,
Michał Młotek
1,
Michalina Perron
1,
Paweł Jóźwik
2,
Bogdan Ulejczyk
1 and
Krzysztof Krawczyk
1
1
Faculty of Chemistry, Warsaw University of Technology, Noakowskiego 3, 00-664 Warsaw, Poland
2
Faculty of Advanced Technologies and Chemistry, Military University of Warsaw, Kaliskiego 2, 00-908 Warsaw, Poland
*
Author to whom correspondence should be addressed.
Catalysts 2021, 11(7), 860; https://doi.org/10.3390/catal11070860
Submission received: 24 June 2021 / Revised: 8 July 2021 / Accepted: 13 July 2021 / Published: 19 July 2021
(This article belongs to the Special Issue Towards Catalysts Prepared by Cold Plasma)

Abstract

Biomass can be considered a renewable energy source. It undergoes a gasification process to obtain gaseous fuel, which converts it into combustible gaseous products such as hydrogen, carbon monoxide, and methane. The process also generates undesirable tars that can condense in gas lines and cause corrosion, and after processing, can be an additional source of combustible gases. This study focused on the processing of tar substances with toluene as a model substance. The effect of discharge power and carrier gas composition on toluene conversion was tested. The process was conducted in a plasma-catalytic system with a new Ni3Al system in the form of a honeycomb. The toluene conversion reached 90%, and small amounts of ethane, ethylene, acetylene, benzene, and C3 and C4 hydrocarbons were detected in the post-reaction mixture. Changes in the surface composition of the Ni3Al catalyst were observed throughout the experiments. These changes did not affect the toluene conversion.
Keywords: glide arc; tar decomposition; nickel catalyst glide arc; tar decomposition; nickel catalyst

Share and Cite

MDPI and ACS Style

Woroszył-Wojno, J.; Młotek, M.; Perron, M.; Jóźwik, P.; Ulejczyk, B.; Krawczyk, K. Decomposition of Tars on a Nickel Honeycomb Catalyst. Catalysts 2021, 11, 860. https://doi.org/10.3390/catal11070860

AMA Style

Woroszył-Wojno J, Młotek M, Perron M, Jóźwik P, Ulejczyk B, Krawczyk K. Decomposition of Tars on a Nickel Honeycomb Catalyst. Catalysts. 2021; 11(7):860. https://doi.org/10.3390/catal11070860

Chicago/Turabian Style

Woroszył-Wojno, Joanna, Michał Młotek, Michalina Perron, Paweł Jóźwik, Bogdan Ulejczyk, and Krzysztof Krawczyk. 2021. "Decomposition of Tars on a Nickel Honeycomb Catalyst" Catalysts 11, no. 7: 860. https://doi.org/10.3390/catal11070860

APA Style

Woroszył-Wojno, J., Młotek, M., Perron, M., Jóźwik, P., Ulejczyk, B., & Krawczyk, K. (2021). Decomposition of Tars on a Nickel Honeycomb Catalyst. Catalysts, 11(7), 860. https://doi.org/10.3390/catal11070860

Note that from the first issue of 2016, this journal uses article numbers instead of page numbers. See further details here.

Article Metrics

Back to TopTop