Skip to Content
MicromachinesMicromachines
  • Article
  • Open Access

25 July 2025

17 Pages

Fabrication of Cu-Al-Mn-Ti Shape Memory Alloys via Selective Laser Melting and Its Nano-Precipitation Strengthening

,
,
,
and
1
Hubei Engineering Research Center for BDS-Cloud High-Precision Deformation Monitoring, Artificial Intelligence School, Wuchang University of Technology, Wuhan 430223, China
2
Institute for Advanced Marine Research, China University of Geosciences, Guangzhou 511462, China
3
Gemmological Institute, China University of Geosciences, Wuhan 430074, China
*
Author to whom correspondence should be addressed.

Abstract

A Cu-11.85Al-3.2Mn-0.1Ti shape memory alloy (SMA) with excellent superelasticity and shape memory effect was successfully fabricated via selective laser melting (SLM). Increasing the energy density enhanced grain refinement, achieving a 90% refinement rate compared to cast alloy, with an average width of ~0.15 µm. Refined martensite lowered transformation temperatures and increased thermal hysteresis. Nanoscale Cu2TiAl phases precipitated densely within the matrix, forming a dual strengthening network combining precipitation hardening and dislocation hardening. This mechanism yielded a room-temperature tensile strength of 829.07 MPa, with 6.38% fracture strain. At 200 °C, strength increased to 883.68 MPa, with 12.26% strain. The maximum tensile strength represents a nearly 30% improvement on existing laser-melted quaternary Cu-based SMAs.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.