Error in Figure
In the original publication [1], there was a mistake in Figure 5c “inverted microscope image of 293T cells after Gel/SA-TA hydrogel coculture for 72 h” as published. During the figure insertion process, an incorrect, though visually similar, figure was inadvertently placed in this position.
The corrected Figure 5c “inverted microscope image of 293T cells after Gel/SA-TA hydrogel coculture for 72 h” appears below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Reference
- Wu, J.; Ma, Z.; Tang, Q.; Yang, R. 3D-Printed Multi-Stimulus-Responsive Hydrogels: Fabrication and Characterization. Micromachines 2025, 16, 788. [Google Scholar] [CrossRef] [Scilit] [PubMed]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2026 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.