Skip to Content
Remote SensingRemote Sensing
  • Article
  • Open Access

21 November 2026

24 Pages

Stable-Area-Constrained Bridging Registration for Monitoring Small Deformations of Rock Slopes Using Terrestrial Laser Scanning

,
,
,
,
,
,
,
,
and
1
College of Water Resource and Hydropower, Sichuan University, Chengdu 610065, China
2
State Key Laboratory of Hydraulics and Mountain River Engineering, Sichuan University, Chengdu 610065, China
3
Institute for Disaster Management and Reconstruction, Sichuan University-The Hong Kong Polytechnic University, Chengdu 610200, China
*
Author to whom correspondence should be addressed.
Remote Sens.2026, 18(23), 4010;https://doi.org/10.3390/rs18234010 
(registering DOI)
This article belongs to the Special Issue Identifying and Monitoring of Landslide and Subsidence Using Remote Sensing Observations

Abstract

Small deformations of large, steep rock slopes may be comparable in magnitude to cross-epoch point-cloud registration errors. Including deforming areas in registration can suppress change signals and introduce apparent changes in stable areas. This study proposes stable-area-constrained bridging registration (SACBR) and applies it to the Feishuiyan quarry slope at the Shuangjiangkou Hydropower Station. Field-observed cracks and surface monitoring monument data are used to select relatively stable reference areas. Cross-epoch rigid transformations are estimated using only stable overlapping areas, and a bridging scan transfers the reference frame to the remaining scans acquired within the same epoch. The two registration workflows are compared using representative cross-sections, surface distances calculated by multiscale model-to-model cloud comparison (M3C2), and statistics for monument neighborhoods. Compared with general whole-cloud registration, SACBR reduces systematic offsets in relatively stable areas and preserves clearer cross-epoch differences in deforming areas. In the selected relatively stable patch, the median signed M3C2 distance was −105.56 mm under general registration and −4.39 mm under SACBR. Because this patch was used to estimate the SACBR cross-epoch transformation, its statistics describe local surface agreement rather than providing an independent estimate of registration accuracy. For each selected monument, we calculated the absolute value of the mean signed M3C2 distance in its neighborhood. The deforming-to-stable-area ratio of the group means was 1.56 under general registration and 2.39 under SACBR. The higher ratio under SACBR describes a stronger contrast between the two sampled groups, not an improvement in registration accuracy. These findings support improved geometric consistency in stable areas and preservation of small-deformation responses under multi-station conditions. Independent check data are needed to determine whether SACBR improves registration accuracy outside the reference terrain.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.