Skip to Content
SustainabilitySustainability
  • Article
  • Open Access

17 November 2026

27 Pages

Mechanical, Thermal, and Sustainability Assessments of Non-Autoclaved Foamed Concretes Stabilized with Guar Gum

,
,
,
,
and
1
Department of Civil Engineering and Building Services Engineering, Faculty of Civil Engineering, Politehnica University Timisoara, Traian Lalescu Street, No. 2, 300223 Timisoara, Romania
2
Faculty of Chemical Engineering, Biotechnologies and Environmental Protection, Politehnica University, Timisoara, V. Parvan Bd. No. 6, 300223 Timisoara, Romania
3
National Institute of Research and Development for Electrochemistry and Condensed Matter (INCEMC), Dr. A. Paunescu Podeanu St., No. 144, 300569 Timisoara, Romania
*
Authors to whom correspondence should be addressed.

Abstract

The development of lightweight cementitious materials with reduced environmental impact represents an important direction for sustainable construction. This study investigates the mechanical and thermal characteristics of non-autoclaved foamed concrete mixtures based on Portland cement, sodium lauryl sulfate (SLS), and guar gum as a bio-based viscosity-modifying additive. The effects of the water-to-cement ratio and mixing time on porosity, density, thermal conductivity, and mechanical strength were investigated. The relationship between porosity and mechanical strength was evaluated using the Ryshkevitch model, while a full factorial experimental design was applied to identify the experimental conditions that maximize flexural and compressive strength while minimizing thermal conductivity. The developed mixtures showed thermal conductivity values between 0.080 and 0.095 W/(m·K), apparent density between 0.41 and 0.71 g/cm3, and total porosity of up to 83.92%. After 28 days, compressive strength ranged from 0.11 to 1.72 MPa, while flexural strength ranged from 0.02 to 0.29 MPa. Both mechanical properties were strongly correlated with porosity, with R2 values exceeding 0.95 across the investigated models. The response analysis and ANOVA results showed that mixing time had the greatest influence on mechanical strength, whereas total water was the dominant factor affecting thermal conductivity. The proposed Sustainability Index (S) exceeded 0.500 for all investigated mixtures, indicating favorable ecological, economic, and technical-structural performances compared with the considered commercial reference materials. The results demonstrate the potential of non-autoclaved foamed concrete incorporating guar gum as a lightweight and thermally insulating material for non-structural construction applications, while avoiding the energy-intensive autoclaving process.

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.