Abstract
This study evaluated seven concrete formulations: an unmodified reference (R0), a steel-fiber comparator (RF), and five mixtures in which 10–50% of the initial sand mass was replaced with dry, irregular cast-iron machining chips (nominal particle size: 0–4 mm). The waste was characterized by sieve analysis, density measurements, and energy-dispersive X-ray fluorescence (ED-XRF). The mixtures were assessed for slump, saturated density, 28-day bending and compressive strength, Böhme abrasion resistance, and responses to 50 freeze–thaw cycles and 48 h of exposure to 5% NaCl fog. Mass-based replacement altered the theoretical aggregate volume and paste-to-aggregate volume ratio; admixture dosage and slump also varied. Specimen-level Dunnett comparisons indicated higher mean compressive strengths for RW2, RW4, and RW5 than for R0 (adjusted p < 0.05), although only one batch for hardened-property testing was produced per formulation. RW5 achieved a mean compressive strength of 48.4 MPa and a reported mean Böhme volume loss of 9.6 cm3, compared with 13.3 cm3 for R0 (a 27.8% reduction). Abrasion resistance thus appears to be the most promising response of these specific formulations, although the density basis used for the original abrasion volume-loss conversion could not be independently verified. Neither the 50-cycle freeze–thaw test nor the 48 h salt-spray exposure establishes long-term frost or chloride durability. The study demonstrates feasibility at the formulation level, rather than an isolated metallic reinforcement mechanism or a generally optimal replacement level.