In the original publication [1], there was a mistake in Figure 1 and Figure 2, and Table 3 as published. Because of the authors’ negligence, the photo and schematic of the bottom frame structure shown in the original publication’s Section 2 were confused with another similar experiment by our research group. The mistakes in Table 3 are the same. The corrected Figure 1 and Figure 2, and Table 3 are shown below. The authors state that the scientific conclusions are unaffected. This correction was approved by the Academic Editor. The original publication has also been updated.
Figure 1.
The floor plans of the bottom frame structure: (a) the bottom floor plan, (b) the standard story plan, (c) the anti-seismic wall plan in the bottom story, (d) the constructional columns in the upon stories.
Figure 2.
The bottom frame model, the layout of strain gauges and the cracking.
Table 3.
The mass parameters of individual stories and the artificial weights.
Reference
- Zhang, L.; Li, R.; Shen, Z.; Liu, B.; Kong, J.; Zhou, G. The Stressing State Features of a Bottom Frame Structure Revealed from the Shaking Table Strain Data. Materials 2023, 16, 1809. [Google Scholar] [CrossRef] [Scilit] [PubMed]
Disclaimer/Publisher’s Note: The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of MDPI and/or the editor(s). MDPI and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content. |
© 2023 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).