In the original publication [1], there was a mistake in Figure 10. The authors apologize for any inconvenience caused and state that the scientific conclusions are unaffected. The correction was approved by the Academic Editor. The original publication has also been updated. Although there is no error in the figure legend, Figure 10A was the duplicate of Figure 10B, as follows:
Figure 10.
Micro-computed tomography (micro-CT) analysis. Quantitative evaluation of the bone volume (BV) between the bone and SAs. The tissue volume (TV, mm3), BV (mm3), and BS (mm2) were examined in a region of interest (ROI) of 200–1000 μm around the implant. (A) BV fraction (BV/TV, %) and (B) BS density (BS/TV, mm−1) represent the BV rate and bone tissue surface rate, respectively. Mean ± SEM. * p < 0.05.
The corrected Figure 10 should be:
Figure 10.
Micro-computed tomography (micro-CT) analysis. Quantitative evaluation of the bone volume (BV) between the bone and SAs. The tissue volume (TV, mm3), BV (mm3), and BS (mm2) were examined in a region of interest (ROI) of 200–1000 μm around the implant. (A) BV fraction (BV/TV, %) and (B) BS density (BS/TV, mm−1) represent the BV rate and bone tissue surface rate, respectively. Mean ± SEM. * p < 0.05.
Reference
- Liu, W.-C.; Chang, C.-H.; Chen, C.-H.; Lu, C.-K.; Ma, C.-H.; Huang, S.-I.; Fan, W.-L.; Shen, H.-H.; Tsai, P.-I.; Yang, K.-Y.; et al. 3D-Printed Double-Helical Biodegradable Iron Suture Anchor: A Rabbit Rotator Cuff Tear Model. Materials 2022, 15, 2801. [Google Scholar] [CrossRef] [PubMed]
Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations. |
© 2022 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/).