Skip to Content
MaterialsMaterials
  • Article
  • Open Access

22 August 2022

12 Pages

Production of Mesoporous Magnetic Carbon Materials from Oily Sludge by Combining Thermal Activation and Post-Washing

,
,
and
1
Graduate Institute of Bioresources, National Pingtung University of Science and Technology, Pingtung 912, Taiwan
2
Department of Resources Engineering, National Cheng Kung University, Tainan 701, Taiwan
*
Author to whom correspondence should be addressed.
This article belongs to the Special Issue Porous Ceramics, Glasses and Composites

Abstract

In this work, the oily sludge (OS) from a local waste oil recycling plant was reused as a precursor for producing porous magnetic carbon composites (CC) by pyrolysis, followed by carbon dioxide activation. Based on the thermogravimetric analysis (TGA) of the OS feedstock, the preparation experiments were performed at 800–900 °C. From the pore analysis of the CC products, it indicated an increasing trend, as the BET surface area greatly increased from about 1.0 to 44.30 m2/g. In addition, the enhancement effect on the pore properties can be consistently obtained from the acid-washed CC products because the existing and new pores were reformed due to the leaching-out of inorganic minerals. It showed an increase from 32.27 to 94.45 m2/g and 44.30 to 94.52 m2/g at 850 and 900 °C, respectively, showing their mesoporous features. These porous and iron-containing features were also observed by the scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDS). In addition, the adsorption removal of total organic carbon (TOC) in the raw wastewater, by the CC product, showed its high performance (>80%).

Article Metrics

Citations

Article Access Statistics

Multiple requests from the same IP address are counted as one view.