Correction: Speranza, V. et al. Hierarchical Structure of iPP During Injection Molding Process with Fast Mold Temperature Evolution. Materials 2019, 12, 424

Vito Speranza; Sara Liparoti; Roberto Pantani; Giuseppe Titomanlio

doi:10.3390/ma13061277

,

and

Department of Industrial Engineering, University of Salerno–via Giovanni Paolo II, 132, 84084 Fisciano (SA), Italy

^*

Author to whom correspondence should be addressed.

Materials2020, 13(6), 1277;https://doi.org/10.3390/ma13061277

Version Notes

Order Reprints

The correction reported in the following has to be applied to the paper [].

Due to an unexpected result of the conversion procedure, the old Figure 8a:

needs to be replaced with the following:

This change does not affect the results and conclusions of the paper. The authors would like to apologize for any inconvenience caused to the readers.

Conflicts of Interest

The authors declare no conflict of interest.

Reference

Speranza, V.; Liparoti, S.; Pantani, R.; Titomanlio, G. Hierarchical structure of iPP during injection molding process with fast mold temperature evolution. Materials 2019, 12, 424. [Google Scholar] [CrossRef] [PubMed]

© 2020 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).

Correction: Speranza, V. et al. Hierarchical Structure of iPP During Injection Molding Process with Fast Mold Temperature Evolution. Materials 2019, 12, 424

Conflicts of Interest

Reference

Article Metrics

Citations

Article Access Statistics